Precautions when using automatic slitter

1. Ensure that the voltage, current and hydraulic equivalents are correct and stable before starting the machine;

2. Before the equipment is ready for operation, all personnel must notify the departure device to ensure personal safety before starting operation;

3. During operation, it is forbidden to touch the running film roll or roll core by hand to avoid personal injury caused by the hand being involved;

4. During the operation, it is forbidden to scratch or cut each roller core with a knife or hard object.

First package: Before the equipment is put into operation, check whether the working positions are properly adjusted. If lubrication is required, the grease should be added in advance. Check if the tool is sharp.

After all the normal, you can run the empty car first, check whether there is any abnormality, and input the processing order into the computer to check the order in advance; after the equipment is put into operation, adjust the optimal working condition of the equipment according to the production situation to ensure the cutting machine pressure. The marks are moderate, the cuts are burr-free, and the trimming positions on both sides are appropriate. Ensure that the cross-cutting machine has smooth paper feeding and accurate cutting length. For vertical and horizontal cutting machines that are connected to production management, it is also necessary to monitor the operation of the machine at the same time to prevent paper jamming and defective products.

After the work is finished, clean the dust and paper scraps on the equipment in time, check the cutters and sharpening grinding wheels, drain the oil in the water purifier and the water in the gas storage tank, and check whether there is any abnormality in the running parts. Then, according to the instructions, cut off the power supply and maintain the computer operating system.